The Pants'Fix ® Holder is a patented device that was awarded at the International Exhibition of Inventions of Geneva and can wear jeans,trousers without having to worry about its length and shoes that you want to bring with it by avoiding pants to touch the ground to sink, absorb germs and dirty prematurely regardless of its excess..

Fully adjustable, the device suits for men, women and children by causing any embarrassment and presents an interesting alternative to hemming your jeans.

We know sometimes people like to wear your jeans with flip flops, and sometimes with heels, and with this product,you can.

Ideal for dancers, breakers and loose pants / baggy pants may be worn with or without shoes and even over boots or snowboard boots.

Video showing the use of shoes with high heels:

• • Le Pants'Fix® Holder, de par son aspect réglable, convient à toute la famille, y compris aux enfants en période de croissance. Polyvalent, il convient parfaitement aux sportifs, aux professionnels de nombreux corps de métiers, aux danseurs et breakers.

    
    

    L'utilisation du Pants'Fix® Holder permet également aux femmes d'ajuster le tombé du pantalon en fonction de la hauteur de leurs talons.Pour l'utilisation avec des talons il est préférable que l'appui soit fait contre le talon du pied et donc que l'adhésif soit collé à sa hauteur; comme dans la vidéo ci-dessous.

    
    
    

     

     

For use with shoes with high heels it is preferable to find the proper high place, gluing the Velcro stickers to half the surface traction of the ankle, to remove the protection and support and put pants against the adhesive once the desired positioning well chosen.

For the system does not change the look of the pants must support, and therefore takes place against the support, resting on the foot Tallon as shown in the video above .Once installed as explained it is always possible to raise or lower the height to fine tune the appearance.

Contenu:

• 1 pair of Pants'Fix ® Holder
• 1 pair of thermo-adhesive (machine washable)
• 3 pairs of Velcro adhesives

+ Instructions

•  

  
  

   

a)		Attach the adhesive about 3 centimetres ( 1.2 inches ) above the hem on the rear inside on the back of your trousers, exactly above the place where the trousers touch the floor. Press hard during 30 seconds.
(Some pants turn slightly at the ankle, it is very important to stick the adhesive on top of where the hem touches the ground. In general, it corresponds the part of the hem that is worn out.)
b)		Place the Pants'Fix®Holder around your ankle with the hanging part towards the heel and the castening part on the inside part of the ankle. Then adjust the size to fit comfortably.
c)		Match the Pants'Fix ® Holder with the adhesive grip, then adjust if necessary the length of the system to prevent the pants touching the ground .
It is advised to place the Pants'Fix ® Holder so that it presses against the back of the shoe.
Long use (machine washable)
d)		WARNING: in order to increase the life of ypur fastener it is advised to round off the three adhesive corners (3) and the thermo-adhesive(2)with scissors. Preheat 15 sec. the pants at 180 ° ** with an iron before placing the thermo-adhesive (matt side on the fabric 1 ). Apply the iron at 180 ° ** on the thermo-adhesive, high pressure, giving a rotation with an intermediate fabric (thin, cotton ). Let it cool down for 5 minutes before handling, remove the transparent film of the thermo adhesive(2) and place the new adhesive in the center with strong pressure for 30 seconds. * washable several times after 24 hours of application, at 40°C, low spin-dry (max 400 rpm), standard washing powder, washing machine with filter. ** Temperature for jeans 100% cotton.
	We decline any responsibility for any potential damages.